Très bien, mais je trouve que la cartographie de poteau d'angle tout à fait tort. Je assumimg vous avez construit et importé le modèle. Cela étant dit, si vous exécutez à travers PoseRay et dans la section des matériaux allez à l'onglet U / V et reaasign la cartographie de cube il fera les briques s'alignent correctement. Comme il n'y a pas do non utilisable dans PoseRay il peut prendre un peu vide, essai et recharger et cycles d'essai pour obtenir les briques échelle correcte mais qui peut être fait dans la même zone de l'onglet U / V.
Very nice but I find the corner post's mapping quite wrong. I am assuming you built and imported the model. That being said if you run it through PoseRay and in the materials section go to the U/V tab and reasign the mapping to cubic it will make the bricks line up correctly. As there is no usable un do in PoseRay it may take a few load, test and reload and test cycles to get the bricks scaling correct but that can be done in the same U/V tab area.
translation by Google Translate...sorry for any confusing errors
Traduction par Google Translate ... désolé pour les erreurs de confusion