Hello,
when i reload a scene with trees and other objects the objects dont appear in the preview window.
But when i render the scene the trees and other things appear in the preview window.
Is this issue known?
Best Regards
Peter
I think I may have noticed that too a few times. I use pause a lot on the preview window, especially with a scene with a lot of objects, so I don't pay close attention. But I know there's been time when an object should have been visible but wasn't. I need to stop and check that out -- maybe disable/enable the object, pause and un-pause the preview, rotate the render camera slightly, etc.
Quote from: jaf on March 19, 2014, 11:49:14 AM
I think I may have noticed that too a few times. I use pause a lot on the preview window, especially with a scene with a lot of objects, so I don't pay close attention. But I know there's been time when an object should have been visible but wasn't. I need to stop and check that out -- maybe disable/enable the object, pause and un-pause the preview, rotate the render camera slightly, etc.
Hi Jaf,
have also rotate the Camera, refresh the preview window, enable/disable the objects, pause and unpause the preview.
Just if i hit the render button the scene will update. Very strange to me...
I have this problem also... :(
You can check visibility in the object tabs or the pop tabs, or with the buttons above the preview. If it's a pop, you might not see it immediately, but if you hit render, it will populate and they should be there.
Quote from: Dune on March 19, 2014, 12:48:24 PM
You can check visibility in the object tabs or the pop tabs, or with the buttons above the preview. If it's a pop, you might not see it immediately, but if you hit render, it will populate and they should be there.
Yes it´s a population and it appears only when i hit render. The Buttons you´ve described dont have any effect to make them visible.
On Object section : select populate all and choose needing update
Quote from: kaedorg on March 19, 2014, 01:34:18 PM
On Object section : select populate all and choose needing update
That´s it! :) Thanks a lot for your hint Kaedorg!