Alright, I know the pumpkin is hovering in midair, i'm fixing that as I type this message. I just wanted to upload what I've done. Also, I have a question that maybe one of you can answer.
I found a jack-o-lantern and placed it in tg2, then I attempted to put my orange light source in the pumpkin, changed the light source to yellow set the source radius to 2 and strength 200. This resulted in the inside of the pumpkin being lit, but light is spilling out behind, under, and to either side of the pumpkin, as well as in front of the pumpkin (like I want it to only do) it's also making it grainy (which i'm not sure how to fix).
In simpler terms, how do I make the light not cast outside the pumpkin where it SHOULD be solid?
You should be able to tell from the pic below what i'm talking about, but if you can't maybe you'll be able to once I get the pumpkin positioned on the ground instead of above it.
===========
JUST TO APPEASE THE CREATIVE COMMONS LICENSE FOR THE JACK-O-LANTERN
I obtained the jack-o-lantern from here ->
http://www.virtual-lands-3d.com/models.html?start=5===========